Reference models: The occasional problem causing freezing and black screen when using face picker with complex reference model objects, especially when rotating the model, has now been fixed. Gusset+ T: The stiffener chamfer is now created to the web of the main part.Įxport to Tekla PowerFab: When assembly marks in Tekla Structures were split by phase, the drawings could get mismatched. Now sinkholes are created into all end plates. Joining plates (14): Previously, galvanizing holes were not created correctly in the second end plate. Welded to top flange (147), Full depth (184): The assembly numbering prefix and start number now correctly use the default value defined in Settings > Options > Components. Kingspan Standard tie bay (10): Previously, when using the component, the hole in the top CSC was not applied. Metsec Horizontal cladding support column (33): Metsec CAM data for the horizontal cladding connection at the column has been updated to correct the cleat positions shown in the CAM.ĬMF Mezzanine floor connection (149): Weld settings are no longer available in the component dialog box. Stiffeners (1034): Previously, the welds between the stiffeners and the part were created in an incorrect position. Metsec File transfer (26): Metsec apex strut CAM data is improved to allow for situations when purlins are set between or below the rafters. When none of the cover thickness values are defined, the default cover thickness is used.įloor layout: The CIP filler part is no longer created outside the component polygon boundaries. Mesh bars, Mesh bars by area: When the cover thickness values for the openings or recesses by cuts are not defined, the cover thicknesses for rebar ends defined on the Bar end condition tab are used instead. Previously, the global orientation was taken into account, and this caused rotated pad footings with starter bars to have different numbering. Starter bars for footing (87) now takes the local plane of the pad footing into account. Previously, if you had the insulation layer as the lower layer and changed the line up direction, the insulation was not created correctly. Formwork placing tools - Walls: On the Conditions tab, when a new sub-condition is created it is automatically selected in the drop down list in the wizard.įloor layout: The Line up direction setting on the General tab now works correctly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |